Thanks My wife and I co-drive a 2012 Shelby GT 500 and have been doing autocross for two years and started track events last year.We need camber in the car for the track; cording the outside of Potenza RE71Rs last year and Hoosier S100s (280/680 R18s on 18"x10" wheels) a few weeks ago. Can/should I use these bolts to get the -1.75 camber (as advertised) for the track to help with tire wear? I have a lowered mustang on lowering springs , and the tires wear faster on the inside.I suppose the coins from the other ones are, as well.Piazza Navona is one of the most beautiful and largest squares in Rome, daily visited by hundreds of tourists coming from all over the world.Tires leaned in real bad installed these bolts and had it aligned, the camber was well within oem spec. After putting on these bolts and straightening out the camber. Especially if you have slightly offset wheels that give your car a wider stance. After recently getting the front tires replaced, the inner sides were completely worn while the outer were not at all.End result is they get the job done I thought I would be ok with my Eibach Pro-kit drop. On the track, I expected the neg camber to help with cornering. Visually you can see the negative camber only on the front, the rear are straight.
We did get to Paris and threw London in for good measure. Hence, sometime this week, if no miracle happens, massive water cuts will be put in place.
Our Nacera blanks are available in many colour nuances and - as a translucent material - fulfil the highest aesthetic requirements.
The base material is yttrium-stabilised zirconium dioxide, which we dye with an iron oxide-free pigment in minimum concentrations and then process into blanks under isostatic pressure.
Apart from caps, anatomically reduced crowns and up to 14-unit bridges (except for Canada where bridges may contain up to 6 units), telescopic work and attachments, Nacera ceramic blanks for CAD/CAM machining in dental technology.
This brand acts as a centrepiece for our global development, production and distribution of semi-finished products for dental technology applications.